Spot elevations not tagging properly

[katysue]

I am trying to tag floor elevations in my auditorium but the elevation tag will only tag the edges of the floor slab. Now since it is an auditorium i see the same floors in the mezzanine view- and i have had no problems tagging the elevations of THE SAME FLOORS anywhere on the floor- it does not limit me to the edges. I am using the same spot elevation tag from first to mezzanine. Does anyone know why this would be? Anyone have any ideas on how i can fix it?

[cliff collins]

Are the floors sloping? if so, are they edited with points, or a slope arrow?

Try going to a section and see if the spot elev. tool works there?

Perhaps post an example?

cheers...

[katysue]

It is not sloped. see attached pdfs of the mezzanine that is tagged properly, the section that is tagged properly, and the first floor that is being a butthead! :)

[cliff collins]

Try creating a Plan Region at one of the lower floor tiers with a custom View Depth,
and see if you can then apply the spot elevation.

I suspect it is something with View Range that's causing the problem.

Also, go to a 3D view and isolate the floor slabs and elevation tags--see if they tag
in the 3D view?

cheers........

[TheViking]

Make sure you are not in wireframe. The spot elevation needs a surface or an edge to work.

[chomie3634272]

Thanks! This helped me just now.