Staircase with multiple landings

[adnama]

Could anyone advise on the best way to model this type of staircase (see attached)?

Should I model it as a single staircase including the landings or simply model 3 separate flights?

How would I model it as a single staircase including risers and flights?

Thanks.

Paul

[pwmsmith]

There it is, but probably not what you were thinking. I don't believe you can make a single stair and have it turn back over itself.

Patrick

[Eric Stewart]

Sure you can.


There it is, but probably not what you were thinking. I don't believe you can make a single stair and have it turn back over itself.

Patrick

[pwmsmith]

Eric,

Now that is cool! I allways got errors when I tried that.

[Eric Stewart]

Do you draw your boundary first, or use the run? I usually use the run and change the boundary later.

[fixin.to]

In my experience, monolithic stairs without railings work ok, but steel stair stringers and railings get confused as seen in the attached. I have not found a method that gets around this. Has anyone else found a solution?