How do you arc an arc wall?

[mark.79279]

I would like to know the easiest way to put some arcs in an arc wall. I have found that you can place a reference plane on the elevation of an arc wall and attach the wall to this, but I am limited to one ref plane.

For example, lets say I have a parapet wall in the shape of an elongated S. I would like to put a few curves on this wall in elevation to match the curve going on in plan. How would I do this? Thanks

[Paul P.]

Try editing the walls profile in elevation.

Regards, Paul.

[beegee]

You cannot edit the elevation profile of an arc wall.

Best bet would be use an in-place void to cut the walls as shown in the attached sketch.

[mark.79279]

thanks, I will try this.

[Paul P.]

Sorry, my bad.