View Full Version : Railing problem
Chad Smith
2004-12-06, 02:01 AM
On the attached image, I have the blue outlined railing components sticking out past the end of the baluster. I put an offset on the starting post, and was expecting the railings to offset back with it, but they didn't.
Where do I find the parameters to correct this?
beegee
2004-12-06, 03:20 AM
The only way I can that situation to work , is by pulling back the main railing, then adding a special end segment railing.
You're left with a joint line between the two and Join Geometry won't work on railings, so you'll have to use the linework tool on that. All a bit messy I'm afraid.
Mr Spot
2004-12-06, 04:15 AM
Where do you find the time BG? lol
beegee
2004-12-06, 05:35 AM
Sorry Chris, but I don't have the time to answer that right now... :roll:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.