This stairs is bad!!!

[dpasa]

The difference between the two images is this... I created the stairs using boundary and risers.I created from level A to level B but it was ment to be from ground to level A...
So when I finished, I went to it's properties and wrote from Level A -1.50m to Level A... The second image shows what happens... I always have problems with such stairs and I think it is not me... I hope the new release can handle this better.

Do you have similar "crazy" cases?

[nancy.mcclure]

Stairs are one of those elements that if a level modification has to happen, it often makes more sense to simply rebuild the stair. Locations and # for the boundary/riser are set in plan, and don't always neatly correspond to the new vertical data.
I would recommend either:
a) Edit the sketch, set the new vertical information there, then re-finish the sketch
or
b) Rebuild the stair

Hope that helps,

[Scott D Davis]

and it might be better to go from one level to the next, both with offsets. Try it and see if that helps. (Rather than Level A to A with offset, go from A to B with offsets)

[thomas.163390]

Nice stairs Dpasa! :D

Btw, those stairs are really easy to make, just...