sonic.max
2010-04-09, 10:42 PM
hello...
I am converting my garage into a recording/mastering studio; & adding a shed wing to serve as the control room.
I have a basic floor plan, showing the width of the block walls & the door openings...
...& also have drawings of every elevation. All drawings are in perfect scale.
I used to use AutoCAD LT, on my old job, but have recently graduated to AutoCAD 2010 Student. &...I used to know how to make simple 3-D drawings in LT...but have long since forgotten (& have no idea where to start in the full program).
Is there a simple method for combining my existing floor plan w/ all the existing elevations to create a 3-D drawing/renderring of the new studio...??? ('cause...I'm not getting the jist of the help files in this category)
thanks very much,
SonicMax
I am converting my garage into a recording/mastering studio; & adding a shed wing to serve as the control room.
I have a basic floor plan, showing the width of the block walls & the door openings...
...& also have drawings of every elevation. All drawings are in perfect scale.
I used to use AutoCAD LT, on my old job, but have recently graduated to AutoCAD 2010 Student. &...I used to know how to make simple 3-D drawings in LT...but have long since forgotten (& have no idea where to start in the full program).
Is there a simple method for combining my existing floor plan w/ all the existing elevations to create a 3-D drawing/renderring of the new studio...??? ('cause...I'm not getting the jist of the help files in this category)
thanks very much,
SonicMax