View referencing

[jmc73]

Ok, I placed an elevation tag on sheet D02, but it's referencing to sheet D01. The two sheets have an overlap using a scope box which is causing this problem, but how do I change the referencing location to be on the sheet I ACTUALLY PLACED the elevation tag on? I don't want to re-place the tag if I don't have to.

Tip: I was able to change it from the overall page (D00) to the sector page by adjusting the "Hide at scales coarser than..." in its properties. But that's the best I got.

Thanks

[kathy71046]

I had a similar problem...

Possible fix:

Find the view it references, remove from sheet, then replace on sheet.
This fixed it so it referenced the view I called it from rather than one on a previous sheet.