iankids
2010-05-05, 08:02 AM
Hi All,
I have had a problem over the past few days where components will end up several metres below the level where they are being inserted.
Scenario:
Ground Floor Level - Select Component - check level in the properties of the component to ensure it is set to the current level - Place the component. The component is inserted in the model 3.5 metres below the level.
Any clues or any on else seeing a similar behaviour.
Cheers,
Ian
I have had a problem over the past few days where components will end up several metres below the level where they are being inserted.
Scenario:
Ground Floor Level - Select Component - check level in the properties of the component to ensure it is set to the current level - Place the component. The component is inserted in the model 3.5 metres below the level.
Any clues or any on else seeing a similar behaviour.
Cheers,
Ian