Motion Sensor - Where's the M?

[tbcprson]

I'm doing a classroom that has a sloped ceiling and I can see the motion sensors, but they are just a dot. On other sheets where I have flat ceilings, I can see the motion sensor with a letter 'M" on it. Why can't I see it on the sloped ceiling? I have tried to change the views, detail levels, etc. Can anyone help me out?

I have attached what it looks like and what it looks like on other sheets.

Thanks!

[Jrobker]

Your out of luck.
Read Roberts post
http://forums.augi.com/showthread.php?t=118739

Anything sloped in revit is difficult to work with.

[RobertB]

Your out of luck.
Read Roberts post
http://forums.augi.com/showthread.php?t=118739

Anything sloped in revit is difficult to work with.The quickest, and dirtiest, solution for you is to create a horizontal workplane at the lowest level of the ceiling and host your annotative elements to that. It's a dirty solution because they won't participate correctly in clash detection nor will they be in the correct position in elevation.

[tbcprson]

Thanks to both of you. Just glad to know that I am not going crazy.