BecFra
2010-06-02, 10:03 PM
I am just noticing today that when I go to load in a new L-Angle Section detail component in an upgraded project (from 09 or 10) with the 2011 DC family and do override existing version and parameters and it says "cannot create type" and list all the types that are the same size for each leg X 1/2" thickness (i.e. 3x3x1/2). and I either have to delete type, or cancel load.
Anyone else having this problem?
After further investigation.. It appears there is a new parameter for the inside radius "r", when I delete that out it reloads just fine! Bleh autodesk! Now to see how bad life will be if I just delete that out...?? Anyone know if any of the other detail component families have this new "r" parameter then?
Anyone else having this problem?
After further investigation.. It appears there is a new parameter for the inside radius "r", when I delete that out it reloads just fine! Bleh autodesk! Now to see how bad life will be if I just delete that out...?? Anyone know if any of the other detail component families have this new "r" parameter then?