Hatch automatically rotating in section views

[goodtastingsteak]

Hello all!

I have tapered rigid insulation modeled as a "roof" with the slopes and all, but when I flip the section view, the hatching seems to rotate 90 degrees. Earlier, the hatching was just gone. Has this ever happened to anyone else? Please see the attached .jpg file.

In the image, the 2 section cuts that look to opposite directions are shown in the plan view.

Thanks!

[Alfredo Medina]

Before this question goes into "the twilight zone" of the next page of threads, you should post a Revit file with that little portion of the project. It is hard to tell what the problem is without looking at the file.