craighowie
2010-07-01, 09:00 AM
Hi there
So I would like to have a toposurface that shows slope lines like the attached image! Is that at all possible in revit?
Thanks
Craig
Alfredo Medina
2010-07-01, 03:57 PM
In Revit, the slope is represented by contour lines, which in this case would run kind of parallel to the top and bottom edges, not perpendicular to them. If you want this kind of representation of the slope, you need to go to the Massing and Site > Site settings dialog box, remove all the settings for contour lines, and then add detail lines over the toposurface.
craighowie
2010-07-22, 06:12 AM
Thanks Alfredo
Appreciate the response.
Craig
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.