Toposurface - Sloped Lines

[craighowie]

Hi there

So I would like to have a toposurface that shows slope lines like the attached image! Is that at all possible in revit?

Thanks
Craig

[Alfredo Medina]

In Revit, the slope is represented by contour lines, which in this case would run kind of parallel to the top and bottom edges, not perpendicular to them. If you want this kind of representation of the slope, you need to go to the Massing and Site > Site settings dialog box, remove all the settings for contour lines, and then add detail lines over the toposurface.

[craighowie]

Thanks Alfredo

Appreciate the response.

Craig