wall wraps - probably a simple question

[rtaube]

I have a 2x4 wall running flush into a 2x6 wall, but I can't seem to get the gypsum board to wrap around that 2" difference.
Maybe it doesn't? Is this more of an issue to think about at detailing?
I've attached a simple file

cheers,
ryan

[Alfredo Medina]

Figure 1: prepare some reference planes.

Figure 2, drag the end of the wider wall to the lower reference plane.

Select the wider wall, and make a duplicate of the type, with just one difference: change the "Wrapping at ends" parameter to "interior".

Figure 3, draw a new wall element with the new wall type, perpendicular to the others. Use Location line : Wall centerline, and use the center reference plane.

Figure 4, using Join Geometry, select the two wider walls.

[rtaube]

Thanks Alfredo, never would have thought of that, so simple