Merlin
2010-07-07, 03:35 AM
Greetings all,
Wondering if others have seen a similar anomoly. I created a toposurface as existing phase and then added a pad. The pad, of course, is just a straight void. But the new toposurface surface shows the adjacent surfaces with a slope towards the pad edge. When you open a section and flick between Existing and New phases, you see this differing loping surface adjacent to the pad. (I first noticed it as I was investigating building heights above natural land levels).
Anyone come across this before?
John Mc
Wondering if others have seen a similar anomoly. I created a toposurface as existing phase and then added a pad. The pad, of course, is just a straight void. But the new toposurface surface shows the adjacent surfaces with a slope towards the pad edge. When you open a section and flick between Existing and New phases, you see this differing loping surface adjacent to the pad. (I first noticed it as I was investigating building heights above natural land levels).
Anyone come across this before?
John Mc