kryptonite_186
2004-12-15, 05:56 PM
Instead of a single overall scale it would be nice to have two separate X and Y scales for hatch patterns. This would allow a user to give the correct appearance when hatching on a sloped surface.
An architectural application of this could be the y scale setting for a shingle pattern on a roof could vary in proportion to the slope of the roof. This would give a drawing the correct appearance especially when varying slopes are used on one roof.
An architectural application of this could be the y scale setting for a shingle pattern on a roof could vary in proportion to the slope of the roof. This would give a drawing the correct appearance especially when varying slopes are used on one roof.