View Full Version : Wall layer lines GONE!
barrie.sharp
2010-07-22, 04:21 PM
Attached jpg says it all. My cavity wall is looking a bit dodgy!
jessica.146534
2010-07-22, 07:45 PM
Has someone maybe used the "invisible line" tool on this? You can try using the "by category" line to rule that out.
You may also want to check in VP that "clean up all wall joins" isn't selected.
shane.249457
2010-07-22, 07:54 PM
look at the wall level constraints.
if the walls goes from level _ to level _, the change the upper constraint to 'unconstrained' with the proper height.
if the wall goes from level _ to unconstrained, choose a level for the top constraint and if necessary enter an offset.
this will most likely fix that graphical error.
i believe it is a glitch.
davidcobi
2010-07-22, 08:27 PM
We saw this problem pop up in 2010. When you have a niche (void) that doesn't cut through the whole wall some of your wall layers (common edges) will disappear.
Moving the offending layers into the core itself solves the problem, but screws up your intersections.
barrie.sharp
2010-07-23, 07:57 AM
OK, that's a bit annoying. Common edges was unticked in VG overides on the view template. Not a setting I ever change so who knows.
Funny thing is, I had a similar issue in the same project where a wall wasn't appearing correctly. If I switched on Reveal Hidden Elements, selected the wall (nothing more) and switched back, the wall would appear normally for a period.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.