View Full Version : ATTRIBUTE EDITING?
CADMama
2010-07-23, 06:50 PM
Anyone had success on editing an attribute with this? I have not tried it and don't have time to mess around with it. I have a former co-worker that just emailed me about it. he says he can't get it to select the particular attribute. It appears to need him to select it.
Any ideas?
Which version of AutoCAD is this problem occurring in?
Can he share the steps and sample drawing?
Does it have to run through the Action Recorder?
darthyoga
2012-03-20, 09:52 PM
I dont know if you will even see this but try editing the attribute through the properties palette. Works like a charm unless two attribute have the same name.
shobhit_kumar02463046
2013-12-13, 05:12 AM
Anyone had success on editing an attribute with this? I have not tried it and don't have time to mess around with it. I have a former co-worker that just emailed me about it. he says he can't get it to select the particular attribute. It appears to need him to select it.
Any ideas?
Dear ,
for attribute.
select that block . and change attribute. value in property .
94385
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.