Model Lines Not Showing

[craighowie]

Hi there.

Can anyone tell me why the model lines that I have drawn on the landing of the attached ramp do not show in plan view!

Thanks,
Craig

[kathy71046]

On level 0 your cut plane is below the top of the model line.

As for the curved portion, I suspect it is very slightly within the mass, as when I set the reamp to transparent it became visible.

[craighowie]

Hi Cathy

Thank you for your reponse! I am more concerned about the model lines not showing in Level 1! The lines on the sloped surface of the ramp show, but the lines on the landing doesnt... What would cause the "curved portion," to be slightly within the mass? When I manually lift the lines they still dont show!

Any other ideas?

[Alfredo Medina]

I don't know why that model line at the landing doesn't show, but if you select those lines and use "Convert Lines" they will be now detail lines; then this arc at the landing will display correctly. I think they should have been detail lines, anyway, since they are just representing the path of the ramp in plan view.

[craighowie]

Thanks Alfredo

Will do just that, thanks for the advise!

Craig

[dhurtubise]

If you switch your view to wireframe you will see them. Looks like you simply picked the wrong work plane.