Pavements

[rgranja508683]

I use one floor for construct the slab and then over I construct another floor for making the pavement for the room. Is this the best solution?
Perhaps Revit need a new component like ceiling for making the pavement.

Ricardo

[beegee]

Ricardo,

The method you are using is one way to get a surface patterned floor as part of a larger floor.

Another way is to paint the floor.with the surface material after splitting the face.

[SCShell]

Hey there,
As was discussed in one of the classed at AU, finish floor elevations and dimensions are usually taken from the concrete slab, not the floor finish (Pavement I assume is what you call the finish).
I actually like to add a finish floor over my concrete to ensure accuracy and make it simple to show certain things on the CD's later. Operator's choice. During Schematic Design, I do simply split surfaces to make it faster and quicker to modify during design.

Good luck
Steve