PDA

View Full Version : Switch to Classic mode



Mac Demer
2010-08-10, 03:51 PM
I've hear there's a way to switch to "classic mode" in Revit 2011. (something with the revit.ini file) It's not supported by Autodesk. Anyone know the steps to do this. I intend to stick with the ribbon but would like to know anyway.

Mike

patricks
2010-08-10, 04:37 PM
just search for "classic mode" or "2009 interface" or something similar in this forum.

Mac Demer
2010-08-10, 05:28 PM
Tried that already with no results. Autodesk states you can't switch to Classic Mode with 2011. BUT there is a way, and it has to do with the revit.ini file. I'm searching for that method.

Thanks,

eric.piotrowicz
2010-08-10, 05:49 PM
This should point you in the right direction
http://forums.augi.com/showthread.php?t=104982&highlight=Revit+classic+interface
Although this was specifically something with 2010, so far i haven't heard of or tried hacking 2011 so i don't know if its going to be the same.

jeffh
2010-08-10, 06:29 PM
Here is a link to the Autodesk Knowledgebase article on how to switch the user interface to a pre 2010 version.

http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=13126336&linkID=9243099