need a little wall cleanup help

[vanderloo5]

Can someone guide me on how to make this radius wall cleanup at wall join. I originally had id drawn as the same wall style as the adjoining walls and it came to a point at cleanup. I would like it to be flat.(see attachment)

[bbeck]

I'll just throw out the obvious knowing that you probably tried this already. Edit Wall Join Tool and cycle through the configuration options.

[vanderloo5]

Thanks Brian but yes I did try that. When selecting the join, I don't get any options in the options bar, (next, butt, miter, square off, etc.) I also made sure they were both set to bearing walls.

[cliff collins]

Try highlighting the blue dot at the end of the walls, right click, and selct "disallow join".

just another idea.

cheers

[bbeck]

Try pulling your arc past the vertical wall and then trimming it back. After that try the Edit Wall Join tool to see if your Options go active.

[cliff collins]

see if this is what you are after.

cheers

[vanderloo5]

Try pulling your arc past the vertical wall and then trimming it back. After that try the Edit Wall Join tool to see if your Options go active.

Already tried the trim idea with no luck. Trying extending the arc wall and using wall join tool I still don't get the options.

Cliff- I was unable to open your link because it is a later version of Revit. Although I have 2011 I am unable to load it on my pc because of processor compatibility issues. So I'm stuck with 2009 until I can upgrade my work station.

[cliff collins]

Sorry--

I only have 2010 and 2011--

But I tried what my previous post suggested by disallow joins and it cleaned up nicely.

Give that a try.

cheers