corridor issue...what is the cause?

[ghines]

I have a corridor that is not drawing correctly. It is made up of several regions depending on the section of corridor in question. The lines are crossing up with each other. i have checked my link codes and point codes they all match up.

If you look at the iso-picture below the corridor feature lines should run parallel to each other. but they do not.

any ideas?

[brian.hailey933139]

Try changing the branching option in the corridro properties:

http://content.screencast.com/users/jugglerbri/folders/Jing/media/e8c716d2-5acf-4757-ac92-4b504349ae30/2010-09-16_1539.png

[ghines]

Thanks Brian,

That fixed it

[KansasCAD]

This reply is to Brian,
I am having a very similar issue but I think it has to do with the point code P2. In some assemblies P2 is in a different place than it is in other assemblies. In the image capture you showed in your post I don't see any codes like P1, P2, etc. Are they just lower on the list, or should I be replacing those codes in the sub assemblies with a specific code that I want to show?

When a subassembly under the parameters tab only shows one point code (such as P2) is this always the connection point that the next subassembly attaches to?

I thought that I was understanding C3D pretty well until I see others posts and then I start doubting what I have been doing.

Thanks,

Daryl