Stairs With Assymetric Stringers

[Limbatus]

Is it possible to use the stair tool to make a spiral staircase where the inner spiral stringer is a 1/2" tube, and the outer stringer is a double 1/4" plate? I don't see any options to set the profiles individually. thanks in advance.

[Scott Womack]

Is it possible to use the stair tool to make a spiral staircase where the inner spiral stringer is a 1/2" tube, and the outer stringer is a double 1/4" plate? I don't see any options to set the profiles individually. thanks in advance.

Not in the stair tool itself. Best bet would be to make the stair without any stringers, and build the stringers in as offset "rails" that are made to look like the stringers.

[Limbatus]

Thanks so much for the solution. I think that will work fine. I was about to delve into adaptive components to try and wrap a sweep up a helix. I think your method is going to save me many hours. thanks.