Service Pack 3 for Autodesk Robot Structural Analysis Professional 2011

[Tomasz.Fudala]

The Service Pack 3 for Autodesk Robot Structural Analysis 2011, and Autodesk Robot Structural Analysis Professional 2011 has been published.

It is available via LiveUpdate and the Product Page: http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=15725768&linkID=13140816

[Mel_S]

And the problems start. After installing the SP3 I can not export the RST drawings to ASD. See the screenshot.

[angel.247184]

hello Tomaz
i have a concern about...
i have 2 level building, very simple, when i do seismic modal analysis i am getting problems in one direction.
not normal solution as i have from other projects..

[angel.247184]

attached the output of the Force solution it does not have sence

[length zero]

@ angel

What u trying to compare
This results are not from same cases,
Can u explore more what u trying to compare

[angel.247184]

Thanks LZ
i already discovered the problem with the high force i had.
i used in my spectrum curve, distance instead aceleratio, when i calculated the program took the distance and converted to acceleration, then i had very high results

[rammedeiros]

When I try to declare/add the ruser database on Job preferences/database/steel and timber sections ,the program shuts down to desktop .

[length zero]

@ angel

Sorry, but i dont understood you again
In previous post you have marked some values with red circles,
You are sceptic that results are greater than normal or what.

Regards