_pedit joining lines

[markwise]

I have a single line for a pipe line in 3D that I want to turn into a continuous polyline. But some corners will not select. Message I get is "The object is not parallel to the UCS." I have the UCS moved to the corner I am working on and in the the x,y plane.

[Mike.Perry]

Hi

Can you post a simple example drawing file (.DWG) should we could take a look.

+

Might want to have a browse the following thread -

Filleting Polylines in 3D??? (http://forums.augi.com/showthread.php?t=8667)

Have a good one, Mike

[jaberwok]

The easiest answer I've found is to create all the various lines then use "3dpoly" to create a new pline (using ENDpoint osnap) over the existing ones.

[markwise]

Thanks Guys I was using the 2D poly line edit. It worked fine with 3Dpoly

Merry Christmas
mark