PDA

View Full Version : Sweeping and Joining Masses



GerG
2010-10-10, 07:28 AM
Hi, I am very new to revit so excuse me for my terminology, but I am trying create two solids that meet at the top.

One solid would be vertical and the other would be vertical then at a certain point will split and meet with the other one at the top.


Basically I am asking how would I go about doing this? I know how to sweep and all that stuff but I can't figure it out after the 1st level.

I have to build the structure of the building in the picture below.

Thanks.

tropitech
2010-10-12, 09:14 AM
i'm finding it a bit hard to match your words to that picture...but if your doing basic modelling only i'd be using voids to cut edges, make the hole etc.

Munkholm
2010-10-12, 09:41 AM
Best practice would probably be to use Conceptual Masses, but for a rookie, the shape can be somehow matched with one swept blend and a void to cut the circle...

BTW, the circle was changed before actual construction, because the Shanghai Mayor would not accept the emblem of the Japanese Rising Sun, on a Chinese building build by Japanese developer Minoru Mori...