ghines
2010-10-21, 09:03 PM
I am trying to figure out how to create a label that reads as such:
STA. 4+00, 15.00' LT
BEGIN DITCH
INV. EL. 98.00
I understand the Station portion and the elevation portion. The part that I do not understand is how to make the profile label read the offset portion. I know that it would have to be done with reference text I presume. You would have to link back to the alignment. The problem is I just get 0.00 returned in the label. Which I presume that is because I am referencing the profile alignment. But, if I reference the ditch alignment the label returns ??? as in it can not determine the command. One would think this can be done. any ideas??
Thanks
STA. 4+00, 15.00' LT
BEGIN DITCH
INV. EL. 98.00
I understand the Station portion and the elevation portion. The part that I do not understand is how to make the profile label read the offset portion. I know that it would have to be done with reference text I presume. You would have to link back to the alignment. The problem is I just get 0.00 returned in the label. Which I presume that is because I am referencing the profile alignment. But, if I reference the ditch alignment the label returns ??? as in it can not determine the command. One would think this can be done. any ideas??
Thanks