wfrst2008
2010-10-30, 02:36 PM
Hi,
I created a roof and assigned one end with "define slope",
since I had the horizontal length (x) and vertical offset (y),
so I input Atan(y/x) to the "Angle" parameter, but Revit warned
me "inconsistent units" , only input an exact angle in degrees was
allowed.
But when I input to the calculator, it did return me with a degree unit.
What's wrong with my concept ?
rgds
Fung
I created a roof and assigned one end with "define slope",
since I had the horizontal length (x) and vertical offset (y),
so I input Atan(y/x) to the "Angle" parameter, but Revit warned
me "inconsistent units" , only input an exact angle in degrees was
allowed.
But when I input to the calculator, it did return me with a degree unit.
What's wrong with my concept ?
rgds
Fung