Hatching section view

[jimmy_goodall]

I'm trying to hatch cut and fill on a section view. I know with a profile view it's possible by going to profile view properties and going to the hatch tab. I can't seem to find this option for section view properties. I could hatch them manually but there's about 100 sections and this seem to change around here pretty quickly so it wouldn't be ideal.
Thanks!

[brian.hailey933139]

What is the purpose of the hatch? If it's to show areas of cut/fill, run the quantity takeoff tools and then disply the results in your sections.

[jimmy_goodall]

Cheers Brian, worked a treat. I wasn't quite sure what you were talking about but after a little playing around and sorting out some styles it's exactly what i needed. Thanks again!

[brian.hailey933139]

I love it when a short answer leads to self discovery! That's one of the best ways to learn!