Handrail with wire mesh "balluster"

[mrdavie]

Following the Mastering Autodesk Revit Architecture 2011, I learned how to create a wire mesh infil for stair railings and guardrails. The wire mesh is a profile. In the attached pdf, the horizontal guardrail looks find but the wire mesh on the sloped portion extends beyond the bottom rail. Obviously, the distance between top and bottom rails is not the same when sloped as when horizontal. So, I can the wire mesh adjust for this difference?

[mrdavie]

My stupid.

I know you all were laughing and that's why nobody replied to my question although it was posted two days ago. Well I figured it out. I can use TWO DIFFERENT RAILING TYPES! A handrail which will be 36 inches high and have the appropriately dimensioned wire mesh baluster AND a type for the guardrails which will be 42" high.