edenreagh2
2010-11-29, 08:46 PM
When creating a custom profile for a curtain wall mullion, I have found that the glazing starts to 'break in' to one side of the profile when it is loaded into the project. The profiles are fairly simple and symetrical. The distortion seems to be confined to just the one side.
(The curtain wall is on a curve, the included angle would be about 174 deg.) Can anyone shed some light on this problem? Moving the profile interior to exterior relative to the centreline of the curtain wall does not seem to have any effect.
(The curtain wall is on a curve, the included angle would be about 174 deg.) Can anyone shed some light on this problem? Moving the profile interior to exterior relative to the centreline of the curtain wall does not seem to have any effect.