William.Gares
2011-02-08, 08:35 PM
What is the best way to add a bend in my pipe network which is linked to it's given alignment? My fear is completing an entire pipe network and having to make a last minute adjustment.
More specifically:
1. Do I need to adjust the alignment and redo the entire pipe network? Or is there a command that will allow the pipe network to automatically adjust to a new change in the alignment geometry? Correct me if I'm wrong but if the alignment is the only way to dictate bends/turns in the pipe, the alignment should be 100% accurate and complete before even using the pipe network settings. If that's the case I fear completeing the pipe network and if one change in geometry is required, I would basically need to restart the whole thing.
More specifically:
1. Do I need to adjust the alignment and redo the entire pipe network? Or is there a command that will allow the pipe network to automatically adjust to a new change in the alignment geometry? Correct me if I'm wrong but if the alignment is the only way to dictate bends/turns in the pipe, the alignment should be 100% accurate and complete before even using the pipe network settings. If that's the case I fear completeing the pipe network and if one change in geometry is required, I would basically need to restart the whole thing.