drafting.33933
2011-02-15, 07:35 PM
If there was an existing thread to this subject, I am sorry for the duplication.
I am very new to the Revit program (20 years with AutoCAD). I have grasped the basics and have been able to create a couple of models. :lol:
I am now working on a round building made from timber columns and parallam rafters. There are pre-engineered trusses for the center section (see enclosed pdf). I need to place 2x12 dimensional lumber for a fascia board at the ends of the parallam rafters, but cannot figure out the means to do so. My framing between my rafters was done using the Beam System - FYI my parameters for my Beam System are the four columns making each bay.
Please help, thanks.
Ted
I am very new to the Revit program (20 years with AutoCAD). I have grasped the basics and have been able to create a couple of models. :lol:
I am now working on a round building made from timber columns and parallam rafters. There are pre-engineered trusses for the center section (see enclosed pdf). I need to place 2x12 dimensional lumber for a fascia board at the ends of the parallam rafters, but cannot figure out the means to do so. My framing between my rafters was done using the Beam System - FYI my parameters for my Beam System are the four columns making each bay.
Please help, thanks.
Ted