andrew.boardman1
2011-03-08, 09:24 AM
I have using the structural detailing for my first time for work on a new school building (80x80).
done my pile caps and have grouped the rebar into each different pile cap ie 2 pile cap, 3 pile cap etc. using element manager, and have told them the quantity of elements ie 10No 2 pile caps.
but if you have the same rebar in different elements the table leaves a blank in the number of elements, is there any way around this can you manual type this in.
and on my 3 pile cap group I have diminishing bars again on the table it give an average length, can it do all the different bar lengths separate instead of average.
done my pile caps and have grouped the rebar into each different pile cap ie 2 pile cap, 3 pile cap etc. using element manager, and have told them the quantity of elements ie 10No 2 pile caps.
but if you have the same rebar in different elements the table leaves a blank in the number of elements, is there any way around this can you manual type this in.
and on my 3 pile cap group I have diminishing bars again on the table it give an average length, can it do all the different bar lengths separate instead of average.