Driveway Connections

[seven_tech]

ok, just a shout out for some help here. I need a little help on a sidewalk project that we have in our office. the sidewalk itself isn't such a big deal. i have my assembly built, my alignment along the connection point, in this case the existing back of curb and my corridor is working fine. the problem i am running into is when i do a driveway connection. i have a pdf attached to this message and hopefully it can explain things a little bit better than i can. Hey, a picture is worth a 1000 words right? i am thinking i will need another assembly or i can probably just do it with feature lines, but i'm not 100% sure on this. if anybody knows of a to do this or can point me to some sort of documentation or instruction, the help would be most appreciated

[Aquaserpent]

What I have done is create an alignment from the edge of pavement and use a basic lane and then used polylines to define the tagets for the driveway transistions and limits.

[mjfarrell]

what one can also do...is insert sample stations in the corridor
then use the Section editor to override the curb height and sidewalk slope parameters to model the driveway.

[dgordon.68443]

in 2012 there are new horizontal conditional sub assemblies that help with including driveways in corridors.

[mjfarrell]

in 2012 there are new horizontal conditional sub assemblies that help with including driveways in corridors.

I think one will still find that over riding the section values is a more direct route than using a conditional assembly for driveways.