Wall problem

[shaunv68276]

:x Two multi component wall styles here. 1 with Wrap at ends, 2 no wrap at ends. When I place a 110 wall into the wrapped wall, the intersection leaves lines I dont want to see. It should look like the wall with no wraps.
The problem seems to lie in the fact that to get the wall to wrap at ends you need to move the components out of the core boundary. which in turn gives you the wrong display when cutting a wall into it. Anyone got a solution. I want it to look like option 2 but with wrapped ends.

[beegee]

1. Set core boundaries each side of interior brick layer and define that layer as structure.
2. Define other two layers as finish.
3. Set wrapping at ends to exterior.
4. Use edit cut profile to trim up the central layer.

refer attached.
Note that the hatching is not as clean as desirable. ( Unsure why this happens. Seems to be a bug with cutprofile )

Alternatively, you can set the core boundaries to surround the interior and central layer and proceed as above. But its then more difficult to clean up the wrapped layer with cut profile.

[shaunv68276]

thanks Beegee, thats how I was doing it The problem is this occurs over 40 times in the project. I dont want to edit each one. Is there no other solution :?

[Steve_Stafford]

Edit wall joins didn't help I assume? I think it might if you haven't tried it. Also you could split the walls leaving short segments of wall that wrap at each end and use a wall that doesn't wrap at the intersection if that combo will cleanup correctly.