Sections

[KGC]

I am having an issue where the section marker is not showing on the framing plans but the sections that are referencing other sections/details are.

So the actual "real" section that is cutting the model is not showing up, but the fake ones used to show the same sections elsewhere on the plan will show up.

Any thoughts?

[Dimitri Harvalias]

Check the 'Hide at Scales Coarser than' parameter in the properties of the section. If it doesn't show up anywhere select it in the browser and change the property.

[KGC]

Tried that, and it is not the issue. I have a coordination plan that shows the sections at 1/8" = 1'-0" and the sheet view is also at 1/8"=1'-0" but it does not show there.

EDIT:

Just found the issue, and I SWEAR that i checked for this on Friday, but the discipline setting for the documentation view was set to Mechanical and not Structural. Either way i feel like an idiot.

Thanks