jessica.146534
2011-04-05, 02:31 PM
I'm trying to add horizontal lines to the elevations of an overhead door family. I used the array command and added a parameter to the # of lines so I can change it for varying door heights. The problem is that I can't get the lines to lock to anything so they will stretch as the width changes. I tried drawing the first line and locking it to the reference planes, but the array seems to lose the locks. And then I tried locking a line in the "edit group" command but I get an error message that says:
"Changes to groups are allowed only in group edit mode. Use the Edit Group command to change to all instances of a group type. You may use the "Ungroup" option to proceed with this change by ungrouping the changed group instances."
Any ideas on how I can lock the lines to the reference planes so they will stretch?
I've attached my family for reference. Thanks in advance for your help!
"Changes to groups are allowed only in group edit mode. Use the Edit Group command to change to all instances of a group type. You may use the "Ungroup" option to proceed with this change by ungrouping the changed group instances."
Any ideas on how I can lock the lines to the reference planes so they will stretch?
I've attached my family for reference. Thanks in advance for your help!