Rafter Level cuts

[CCI Design]

Guys, My post is similar to the rafter cut at the wall plate. That doesn't bother me as it doesn't affect the elevations and can be easily fixed in the sections. The problem that I can't seem to work around is if I have a 91/2" rafter on a 12/12 pitch and a 5 1/2" fascia board. In my elevations I have 5 more inches of rafter beyond the bottom of the fascia board because Revit isn't a carpenter and won't cut level over. I have noticed that I can make the roof cut level with the top of the wall which helps the elevation but not the section. Has anyone run against that?

[patricks]

Again look at this thread: http://forums.augi.com/showthread.php?t=12477&page=2&pp=10&highlight=roof+rafter+truss

You need to specify the two-cut plumb type and then you can set the fascia depth to match the size of your fascia boards.