Balusters - how do you control the top cut angle?

[timsea81]

I'm using the default square 2" baluster with a railing for a deck. I want the top to be shown at an angle. If I open the family for the baluster directly there is a parameter called "top cut angle" that adjusts the angle of baluster at the top, however when I deal with it in a project it is always flat on the the top. When I look in the properties of the baluster the "top cut angle" is nowhere to be found. How do I adjust this from within the project?

[Dimitri Harvalias]

In that default baluster the top cut angle is controlled by the angle of the top rail. This angle is the one parallel to the rail. From your description you have a horizontal railing that you want to have a sloped top perpendicular to the rail sketch line, correct?
You'll need to modify the default baluster or create a new one with the void cut created in the front/back plane not the left/right plane.