Add In Tab Dissappeared

[konetarchitecture]

I just upgraded from Revit Architecture 2011 to 2012 and my ADD IN tab dissappeared! I have BlueBeam installed on my computer and it was working like a charm in 2011. I "repaired" bluebeam from it's file but it is still a no-show on my ribbon. I contacted Bluebeam support online but I was wondering if any of the geniuses on this forum have a solution.

FYI Bluebeam is a software that converts .rvt files to .pdf with a simply click, when it is visible on the ribbon.

[Brian Myers]

I've not tried Bluebeam with 2012, but a repair likely wouldn't make it show up. Try to reinstall the software (completely) and see if it associates itself with Revit at that point. A repair will normally just reload drivers, etc. but that's not the same as installing itself on a new piece of software.

[konetarchitecture]

Thanks Brian.
I just dug a bit deeper on the Bluebeam Support page and I discovered that Bluebeam does not support 2012. :0( I am going to contact them tomorrow and see if and when there will be an update to their software.