Getting Area of Sloped Walls Created by Mass

[gkenens]

We are modelling a building with several sloped curtain walls for an estimating schematic. However, both in Vico Office or Revit's built-in schedules, we are unable to obtain the area of the sloped curtain walls. We have tried both a custom wall family as well as a curtain system. The other walls attached to the mass document correctly. We have also tried calculation by panel, using a custom panel in the sloped walls, but the panels are not all of uniform size so this does not work.

Any help or ideas are appreciated!

[cliff collins]

Try setting the Maximum Distance to None for the Grids--which will make it a single panel,
then click it to get the area in properties.

Or, you should be able to set up a Material Takeoff schedule and get the Material Area with Grand Total
for all the glazed panels.

cheers

[gkenens]

Try setting the Maximum Distance to None for the Grids--which will make it a single panel,
then click it to get the area in properties.

Or, you should be able to set up a Material Takeoff schedule and get the Material Area with Grand Total
for all the glazed panels.

cheers
Thanks! That worked!