hdjohnson
2003-10-14, 08:04 PM
I was trying to create a profile to use at the edge of the garage slab; however, it didn't workout too good. I have a few questions:
1) I used the linework tool to remove the edges of the footing profile in the distance; however, the fill pattern still remains. How do you get rid of this? I know I can change the view range; however, I would like to have the window displayed.
2) Is there any way to get the profile and the slab to match up so you don't have to edit out the lines where they meet?
3) I tried attaching parameters to the file so that I could specify the depth and width of the footing; however, it doesn't appear that I can change these values.
Any help would be greatly appreciated.
1) I used the linework tool to remove the edges of the footing profile in the distance; however, the fill pattern still remains. How do you get rid of this? I know I can change the view range; however, I would like to have the window displayed.
2) Is there any way to get the profile and the slab to match up so you don't have to edit out the lines where they meet?
3) I tried attaching parameters to the file so that I could specify the depth and width of the footing; however, it doesn't appear that I can change these values.
Any help would be greatly appreciated.