Poll on Adjusting Pendant Light Fixture Supports

[RobertB]

I've had a request from one of my modelers that pendant lighting fixtures have independently adjustable lengths for the supports. My initial reaction is that I don't care if a support on a sloped surface runs into the ceiling/roof element on the low side of the slope. And on some pendant light fixtures that might mean 4 indepentent adjustments if there were 4 supports. I'm fine with a single support depth that meets the egde of the sloped surface on the high side and runs into the structure on the low side. What are your thoughts?

[mwiggins121466]

Have not seen you around these parts in awhile. Hope your well.

[RobertB]

Have not seen you around these parts in awhile. Hope your well.Thanks. I've been swamped at work and rather busy in my personal life. I don't think things will settle down until after the first of the year. But I'm glad to be back on the RMEP forums. ;)

[mwiggins121466]

We are glad to have you!

[UpNorth]

The larger issue is how the fixture will appear in the architects sections. It is not acceptable to have the supports projecting up into the ceiling.

[JoelLondenberg]

I voted yes...but I think it should be done on a case by case basis. I always prefer to start simple and move toward more complicated as needed.

[ree.espinoza]

I too voted yes. This is particularly important when working with sloped surfaces penadants are connected to. If the default could be equall and then uncheck if need to adjust.