BillB_UH92
2011-11-15, 03:13 PM
"Wall and instance have different phase settings. Automatic creation of infilling wall fails."
After easily making triangular openings for "Windows"* in a gable end wall, I have this problem in the opposite gable: the void extrusion cuts the wall, but Revit gives the above warning during the Cut Geometry command and if you try to erase the yellow void extrusion afterward, the new wall opening vanishes also.
The phase for my generic model-void extrusion used for the cutting and the phase of the wall both seem to be "New Construction" A portion of my project file is attached. Any suggestions would be most appreciated.
Thanks very much
*File is attached. I had simple glass and wood extrusions to resemble a window, not a system family triangular window which I hope to learn to make some other time. This worked well enough on the first gable end.
After easily making triangular openings for "Windows"* in a gable end wall, I have this problem in the opposite gable: the void extrusion cuts the wall, but Revit gives the above warning during the Cut Geometry command and if you try to erase the yellow void extrusion afterward, the new wall opening vanishes also.
The phase for my generic model-void extrusion used for the cutting and the phase of the wall both seem to be "New Construction" A portion of my project file is attached. Any suggestions would be most appreciated.
Thanks very much
*File is attached. I had simple glass and wood extrusions to resemble a window, not a system family triangular window which I hope to learn to make some other time. This worked well enough on the first gable end.