siding flare

[noah]

I'd like to create a siding flare (craftsman style with cedar shakes). The flare is going to start at the second level and flare down and out to cover the floor plate. I figured out how to pull the sheathing and siding down (unlock them) to cover up the floor joists. I also figured out how to add a sweep profile. However, I created my own flare profile based on an existing one. But when I go to load the profile in the sweeps dialogue doesn't show up. I confirmed that it is loaded in the project but it just won't show up in the profile drop down within the sweeps list. ???????????

Any ideas? Thanks!

[aaronrumple]

If it shows in the browser, but not in the drop down list - it is an invalid profile. You are limited to one closed loop, and no overlapping lines.