Reveals around an arch

[mwister]

Here is my problem, I created an in place family to punch an arched hole in the wall, and place a swept precast profile within. I have placed reveals on the wall itself with no problem, and also did the same on the swept precast piece within the family(although only horizontally) by using a swept void.. how would I go about creating this around the radius of the arch now? Or am I even going about this the most logical way seeing as I have only been using Revit for a week or so? Thanks.

Matt

[beegee]

This was a quick exercise. I used a wall for the interior arch, so that I could quickly place and align the reveals, horizontally and vertically. For the angled reveals, I used a void extrusion and arrayed it radially, then mirrored.