need annotative line types for piping

[rmclemore]

I'm doing a lot of piping and could save a lot of time if mlines were annotative. what i want is for pipes to show as a single line on drawings that have a viewport scale of 1/8" and above and drawing smaller than 1/8" scale to show double line. is there any way to do this or a work around besides extra layers?

[cadtag]

other than third party or custom software? not that i know of.

Mlines are pretty limited in what they can/cannot do, and what they do do, they don't do well. So if you do a lot of piping, software to do that would be worthwhile.

[dgorsman]

+1

Double-line piping is supposed to be "true" width; not sure I would trust MLINE to get the correct spacing.