huygen47
2005-01-21, 08:19 AM
Well actually the dwg-file was made exporting from Arris..
but the Dwg-file turned out great when i viewed in Autocad. Or other Dwg viewing software.
but in Revit certain blocks were turned? not even in exactly 90 degrees.
did anyone ever experience this problem before?
Alex
but the Dwg-file turned out great when i viewed in Autocad. Or other Dwg viewing software.
but in Revit certain blocks were turned? not even in exactly 90 degrees.
did anyone ever experience this problem before?
Alex